How To Check A Water Heater Thermostat. The basic part of checking the thermostat of your water heater is to check for continuity. This will mean that the hot water will quickly run out or you only get lukewarm water.
This will mean that the hot water will quickly run out or you only get lukewarm water. Electric water heaters have one or two elements, and each is controlled by a thermostat. Place your leads across the 2nd set of terminals from the top and you should get 240 volts.
The guide below is for checking the electric water heater from the rheem/ruud manufacturer, and it can be used for other brands as well. But hot water also relaxes tired muscles and makes you feel better. Test the electric water heater thermostats with a multimeter.
Then switch the hvac back off. Start by checking the thermostat terminals for the supply of power. Water heater thermostat is typically a thermistor that produces a small amount of electric current to respond to heat.
Below are steps on how to test the water heater thermostat. Use a 1/4 inch nut driver or flathead screwdriver to remove the access cover from the upper and lower thermostat. Turn off the power supply and insert a voltmeter.
Replace the access and insulation panel. Turn off the power supply. Set your thermostat to read voltage.
It goes off if the water in. Check the power to the water heater using the. Complete element & thermostat kit:
Comments
Post a Comment